H3C S5100-SI Operation Manual page 454

port and cannot be configured with the functions like VLAN-VPN, port loopback
detection, port security, and so on.
You cannot modify the duplex mode, port rate, and MDI attribute of a reflector port.
Only an existing static VLAN can be configured as the remote-probe VLAN. To remove
a remote-probe VLAN, you need to restore it to a normal VLAN first. A remote port
mirroring group gets invalid if the corresponding remote port mirroring VLAN is
removed.
Do not configure a port connecting the intermediate switch or destination switch as the
mirroring source port. Otherwise, traffic disorder may occur in the network.
Configuration on a switch acting as an intermediate switch
1) Configuration prerequisites
The trunk ports and the remote-probe VLAN are determined.
Layer 2 connectivity is ensured between the source and destination switches over the
remote-probe VLAN.
2) Configuration procedure
Table 1-4 Follow these steps to perform configurations on the intermediate switch:
To do...
Enter system view
Create a VLAN and enter
VLAN view
Configure the current VLAN
as the remote-probe VLAN
Return to system view
Enter the view of the
Ethernet port connecting to
the source switch,
destination switch or other
intermediate switch
Configure the current port
as trunk port
Configure the trunk port to
permit packets from the
remote-probe VLAN
Configuration on a switch acting as a destination switch
1) Configuration prerequisites
The destination port and the remote-probe VLAN are determined.
Layer 2 connectivity is ensured between the source and destination switches over the
remote-probe VLAN.
2) Configuration procedure
Use the command...
system-view
vlan vlan-id
remote-probe vlan enable
quit
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
1-7
Remarks
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—
—
Required
By default, the port type is
Access.
Required