H3C S5100-SI Operation Manual page 422

To do...
Enter system view
Configure traffic
redirecting
3) Configuring traffic redirecting for a port group
Follow these steps to configure traffic redirecting for the incoming packets in a port group:
To do...
Enter system view
Enter port group view
Configure traffic
redirecting
4) Configuring traffic redirecting for a port
Follow these steps to configure traffic redirecting for the incoming packets on a port:
To do...
Enter system view
Enter Ethernet port view
Configure traffic
redirecting
If traffic is redirected to a Combo port in down state, the system automatically redirects the
traffic to the common port in up state corresponding to this Combo port. Refer to the Basic
Port Configuration module of this manual for information about Combo ports.
User-defined traffic classification rules for traffic redirecting in the global scope or for a
VLAN take precedence over the default rules used for processing protocol packets. The
device will execute traffic redirecting preferentially, which may affect device management
implemented through Telnet and so on.
Use the command...
system-view
traffic-redirect vlan vlan-id inbound
acl-rule interface interface-type
interface-number
Use the command...
system-view
port-group group-id
traffic-redirect inbound acl-rule
interface interface-type
interface-number
Use the command...
system-view
interface interface-type
interface-number
traffic-redirect inbound acl-rule
interface interface-type
interface-number
1-33
Remarks
—
Required
Remarks
—
—
Required
Remarks
—
—
Required