Configuring The Type Of Radius Servers To Be Supported; Configuring The Status Of Radius Servers - H3C S5100-SI Operation Manual

Configuring the Type of RADIUS Servers to be Supported

Follow these steps to configure the type of RADIUS servers to be supported:
To do...
Enter system view
Create a RADIUS scheme and
enter its view
Configure the type of RADIUS
servers to be supported
If you change the RADIUS server type, the units of data flows sent to RADIUS servers will be
restored to the defaults.
When the third party RADIUS server is used, you can select standard or extended as the
server-type in a RADIUS scheme; when the CAMS server is used, you can select extended as the
server-type in a RADIUS scheme.

Configuring the Status of RADIUS Servers

For the primary and secondary servers (authentication/authorization servers, or accounting servers) in
a RADIUS scheme:
When the switch fails to communicate with the primary server due to some server trouble, the switch will
turn to the secondary server and exchange messages with the secondary server.
After the primary server remains in the block state for a set time (set by the timer quiet command), the
switch will try to communicate with the primary server again when it receives a RADIUS request. If it
finds that the primary server has recovered, the switch immediately restores the communication with
the primary server instead of communicating with the secondary server, and at the same time restores
the status of the primary server to active while keeping the status of the secondary server unchanged.
When both the primary and secondary servers are in active or block state, the switch sends messages
only to the primary server.
Use the command...
system-view
radius scheme
radius-scheme-name
server-type { extended |
standard }
2-15
Remarks
—
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Optional