Figure 2-5 HyperTerminal CLI
4)
You can then configure the switch or check the information about the switch by executing the
corresponding commands. You can also acquire help by typing the ? character. Refer to related
parts in this manual for information about the commands used for configuring the switch.
Console Port Login Configuration
Common Configuration
Table 2-2 Common configuration of console port login
Configuration
Console port
configuration
AUX user interface
configuration
Terminal
configuration
Optional
Baud rate
The default baud rate is 9,600 bps.
Optional
Check mode
By default, the check mode of the console port is set to
"none", which means no check bit.
Optional
Stop bits
The default stop bits of a console port is 1.
Optional
Data bits
The default data bits of a console port is 8.
Configure the
command level
Optional
available to the
By default, commands of level 3 are available to the
users logging in to
users logging in to the AUX user interface.
the AUX user
interface
Optional
Make terminal
By default, terminal services are available in all user
services available
interfaces
Set the maximum
Optional
number of lines the
By default, the screen can contain up to 24 lines.
screen can contain
Remarks
2-4