Link Aggregation Configuration; Configuring A Manual Aggregation Group - H3C S5100-SI Operation Manual

Link Aggregation Configuration

The commands of link aggregation cannot be configured with the commands of port loopback
detection feature at the same time.
The ports where the mac-address max-mac-count command is configured cannot be added to
an aggregation group. Contrarily, the mac-address max-mac-count command cannot be
configured on a port that has already been added to an aggregation group.
MAC-authentication-enabled ports and 802.1x-enabled ports cannot be added to an aggregation
group.
Mirroring destination ports and mirroring reflector ports cannot be added to an aggregation group.
Ports configured with blackhole MAC addresses, static MAC addresses, multicast MAC addresses,
or the static ARP protocol cannot be added to an aggregation group.
Ports where the IP-MAC address binding is configured cannot be added to an aggregation group.
Port-security-enabled ports cannot be added to an aggregation group.
The port with Voice VLAN enabled cannot be added to an aggregation group.
Do not add ports with IP filtering enabled to an aggregation group.
Do not add ports with ARP intrusion detection enabled to an aggregation group.
Do not add ports with source IP addresses/source MAC addresses statically bound to them to an
aggregation group.
A port belonging to a port group cannot be added to an aggregation group. Conversely, a port
belonging to an aggregation group cannot be added to a port group.

Configuring a Manual Aggregation Group

You can create a manual aggregation group, or remove an existing manual aggregation group (after
that, all the member ports will be removed from the group).
For a manual aggregation group, a port can only be manually added/removed to/from the manual
aggregation group.
Follow these steps to configure a manual aggregation group:
To do...
Enter system view
Create a manual aggregation
group
Enter Ethernet port view
Add the Ethernet port to the
aggregation group
Note that:
1) When creating an aggregation group:
Use the command...
system-view
link-aggregation group agg-id mode
manual
interface interface-type
interface-number
port link-aggregation group agg-id
1-6
Remarks
—
Required
—
Required