Replacing An Auxiliary Light Bulb - Yamaha Xenter HW151 Owner's Manual

1. Turn signal light bulb
3. Remove the burnt out bulb by
pushing it in and turning it coun-
terclockwise.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
NOTICE
If a turn signal light bulb of differ-
ent wattage than recommended is
used, the turn signal light fl ashing
may be affected.
5. Install the socket (together with
the bulb) by turning it clockwise.
6. Install the cowling.
PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing an auxiliary light
1
bulb
If an auxiliary light bulb burns out, re-
place it as follows.
1. Remove cowling A. (See page
6-7.)
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
ECAU0080
1. Auxiliary light bulb socket
EAUT3640
1. Auxiliary light bulb
3. Remove the burnt out bulb by
4. Insert a new bulb into the socket.
1
5. Install the socket (together with
6. Install the cowling.
6-30
1
pulling it out.
the bulb) by turning it clockwise.
EAU1722A
1
2
3
4
5
6
7
8
9