Replacing A Front Turn Signal Light Bulb; Replacing A Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha XMAX YP125R Sports Owner's Manual

Replacing a front turn signal
light bulb
1. Place the scooter on the center-
stand.
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
1. Turn signal light bulb
2. Turn signal light bulb socket
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by turning it clockwise.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU43051
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
1. Place the vehicle on the center-
stand.
2. Open the seat. (See page 3-17.)
3. Remove panel A. (See page 6-8.)
4. Remove the tail/brake light unit by
removing the screws.
TIP
For the Business version, the rear car-
rier and travel trunk are not shown for
better understanding.
For the Sport version, the backrest is
not shown for better understanding.
1. Screw
EAUM2860
TIP
This model can be equipped with two
different types of tail/brake and rear
turn signal units.
Tail/brake light unit type A
1. Remove the tail/brake light and
1. Dust protector
2. Tab
6-31
turn signal light bulb holder togeth-
er with the dust protector by press-
ing the tab, and then pulling both
outward.
6