Installing Or Replacing A Hot-Swap Hard Disk Drive - Lenovo ThinkServer TS440 User Manual

10. Align the top edge of the EMI-protective panel with the top side of the hard disk drive cage, and then
pivot the EMI-protective panel down until it snaps into position.
Figure 57. Installing the EMI-protective panel
11. Disconnect the SATA cable for the removed non-hot-swap hard disk drive from the system board and
save the cable for future use.
12. Close and lock the front door.
13. If you are instructed to return the old non-hot-swap hard disk drive, follow all packaging instructions and
use any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 141. Then, you
might need to reconfigure RAID for your server. See "Configuring RAID" on page 55.

Installing or replacing a hot-swap hard disk drive

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 63.
This topic provides instructions on how to install or replace a hot-swap hard disk drive.
This topic applies only to server models that have hot-swap hard disk drives installed. See "Features" on
page 7 for more information about the supported hot-swap hard disk drives.
For a list of ThinkServer hard disk drive options, go to:
http://www.lenovo.com/thinkserver
.
Chapter 6 Installing, removing, or replacing hardware
101