Removing A Non-Hot-Swap Hard Disk Drive - Lenovo ThinkServer TS440 User Manual

13. Align the top edge of the EMI-protective panel with the top side of the hard disk drive cage, and then
pivot the EMI-protective panel down until it snaps into position.
Figure 53. Installing the EMI-protective panel
14. Close and lock the front door.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 141. Then, you might
need to reconfigure RAID for your server. See "Configuring RAID" on page 55.

Removing a non-hot-swap hard disk drive

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 63.
This topic provides instructions on how to remove a non-hot-swap hard disk drive.
This topic applies only to server models that have non-hot-swap hard disk drives installed. See "Features"
on page 7 for more information about the supported non-hot-swap hard disk drives.
Before you begin, review the following hard disk drive installation rules:
• Follow the order of the hard disk drive bays when installing a hard disk drive. See "Server components"
on page 22 to locate the hard disk drive bays in your server.
• For RAID configuration, the hard disk drives must be the same type with the same capacity if they are
within a single RAID array. For more information, see "Configuring RAID" on page 55.
• For hard disk drives with different capacities, install the hard disk drive by following the order of the hard
disk drive bays as well as the order from the lowest capacity to the highest capacity.
.
Chapter 6 Installing, removing, or replacing hardware
97