Download Print this page
GE WPRE8150KWT Installation Instruction

GE WPRE8150KWT Installation Instruction

General electric washer installation instructions
Hide thumbs Also See for WPRE8150KWT:

Advertisement

Quick Links

Circles or ovals are color matched
between pictures to help show
location on product
Tools you will need
Phillips Head
Slip Joint
Level
Screwdriver or 1/4"
Pliers
Nut Driver
Installation Instruction - Quick Reference Guide
GE imagination at work
For the complete and detailed installation instructions as well as all safety concerns and warnings, please refer to the installation instructions manual.
2. Remove metal rod from
1. Unpack your washer
Styrofoam block &
owner's manual
Fill hoses
and parts
bag
Drain
hose
Avoid a
Repair!
5. Connect water supply
hoses to wall faucets
Install screens.
(Screens
should be
brand new.
Replace
them if
they are old
or worn).
Use pliers to
tighten 1/2
turn beyond
hand-tight
Avoid a
Install screen washers; without
them debris will clog the valve
and flooding will occur
Repair!
Avoid a
Avoid a
Do not mix hot and cold water
supplies. Mixing them will
result in poor wash perfomance
Repair!
Repair!
3. Install drain hose to the
bottom right
Remove rod by pulling on
yellow plastic handle
Avoid a
Remove metal rod. Leaving rod
in place WILL result in severe
damage to the washer
Repair!
6. Connect drain hose
to drain opening
Use cable tie
clip
Avoid a
Repair!
Avoid a
Meet 30" drain hose height
requirement. Less than 30"
without U clip WILL NOT allow
proper washer operation
Repair!
Dele la vuelta para instrucciones en español
4. Connect water supply
back of the washer
hoses to back of washer
Use screwdriver
Install washers. (Washers should
be brand new. Replace them if
they are old or worn). Use pliers
Avoid a
Use clamps and screws for drain
hose installation; without them
leaks and flooding may occur
Repair!
7. Level your washer
and plug it in
Congratulations! Your installation is successful and complete.
Refer to your Owner's Manual for operation instructions.
Tilt washer
forward 4 to 6
Level
inches and
front legs
then set it back
left to right
down – rear legs
will self-align
Ensure washer is properly
leveled, otherwise damage
WILL occur
Avoid a
Ensure that washer is powered
by 115V, 15 or 20 amp wall
receptacle
Repair!
to tighten 1/2 turn beyond
hand-tight
Do not cross thread the water
hoses and do not forget to
install the washers. Flooding
may occur
8. Installation
complete!
Check for leaks after you turn
on the water

Advertisement

loading

This manual is also suitable for:

Washer