Honeywell C8600A Owner's Manual page 13

NOTICE
If no battery is installed, the battery
door will not close and the unit cannot
be attached to the mounting bracket.
6. Listen for the alarm to beep once to indi-
cate correct battery installation.
7. Holding the alarm with the front facing
you; place the mounting holes of the
alarm over the mounting hooks of the
mounting plate.
8. Turn the alarm in the direction of the On
arrow on the alarm cover until it locks in
place. See Fig. 6.
NOTE: A tamper-resistant locking pin is pro-
vided in the bag with the screws and
anchors. Use this pin to deter children
and others from removing the alarm
from the mounting plate.
9. To use the tamper-resistant locking pin,
insert it into the hole in the side of the
alarm after the device is installed on the
mounting plate; see Fig. 7.
NOTE: To change the battery, remove the
tamper-resistant pin using a long-
nosed pliers.
10. Use a long-nosed pliers to pull out the
tamper-resistant locking pin to allow
removing the device from the mounting
plate to replace the battery.
11. Locate the two self-adhesive labels in the
packing box. Write the telephone number
of the emergency service provider and a
qualified technician in the spaces
provided on the labels.
13 69-1513EF—01