Scanning Documents Using Page Turning Detection - Fujitsu ScanSnap SV600 Basic Operation Manual

Scanning Documents Using Page Turning Detection

This section explains how to detect page turning to start scanning automatically.
ATTENTION
When the installation environment of the ScanSnap or the specification of the book to be scanned
encounters any of the following, use timed mode to scan a document.
l Installation environment of the ScanSnap
- The ScanSnap is installed under direct sunlight
- The ScanSnap is installed under lighting that emits a lot of infrared rays such as incandescent
lamps
- The ScanSnap is under uneven lighting caused by some environmental factors such as the use
of a spotlight
- An object other than the book to be scanned is placed on the Background Pad
- A device that emits infrared light such as a heater is placed near the ScanSnap
- Movement of shadow such as a person appears on the Background Pad
l Book specifications
Books that are smaller than A4 (210 × 297 mm)/Letter (8.5 × 11 in. (216 × 279.4 mm)) when
opened in a double-page spread
Example: Comic books or pocket edition books
HINT
When scanning a document, you can also enable page turning detection by holding down the [Scan]
button on the ScanSnap for 2 seconds or longer. When this is the case, after you finish scanning the
documents, page turning detection becomes disabled again.
1.
Right-click the ScanSnap Manager icon
the [Scan Button Settings] from the
a The
"ScanSnap Setup Dialog Box" (page 43)
2.
In the ScanSnap setup dialog box, select the [Scanning] tab, and click the
[Option] button.
Scanning Documents Using Page Turning Detection
in the notification area, and select
"Right-Click Menu" (page
appears.
68
41).