Advertisement
Voice Mode
When Voice mode is enabled, the keypad announces basic system arming status
upon arming or disarming (e.g., "Disarmed, Ready to Arm," "Armed Away").
To enable the Voice mode: Adjust the keypad volume to "On" or "Check" (at the
desired volume).
To disable the Voice mode: Adjust the keypad volume to "Off."
Note: See To Adjust the volume in the Message Center section.
Voice Chime
Each keypad can be set to announce faulted (opened) entry/exit or perimeter
zones when the control panel's Chime mode is on.
To enable the Voice Chime mode: Adjust the keypad volume to "On" or
"Check" (at the desired volume) and turn on the keypad Chime mode
(Code +
When enabled, Voice Chime provides a voice status annunciation,
chime and display when any entry/exit or perimeter zone is faulted.
When the Voice mode is disabled but Chime mode is enabled, the
sounder will still provide Chime annunciations when zones are faulted.
Voice Status
The keypad can be set to announce current system status and display any
system and/or zone faults (if they exist).
To enable Voice Status: make sure Voice Chime mode is on (see previous
section), then:
•
To Announce Status: Press
The respective system status is announced (e.g., "Disarmed, Ready to
Arm" or "Disarmed, Not Ready to Arm").
Note: Status cannot be announced during the Exit Delay period.
•
To Announce Faults: Press
key a second time within 10 seconds of the first press.
Up to 3 faulted zones are announced with their zone descriptors, if
programmed. If zone descriptors are not programmed, the respective
zone numbers are announced.
FUNCTION KEYS
The Function keys may be programmed by the installer
for special functions or alarm activations. Key pairs
may also be programmed for alarm activations.
To activate the Function keys, press and hold the key
for at least 2 seconds; key pairs are activated
immediately.
Check with the system installer for more information.
).
+
+
- 5 -
+
key once.
+
and the
A or
and
B or
and
C or
and
D
Advertisement
