HBA Installation Manual
LPe12000, LPe12002 and LPe12004

Advertising

   Related Manuals for Lenovo LPe12000

No related manuals

   Summary of Contents for Lenovo LPe12000

  • Page 1

    HBA Installation Manual LPe12000, LPe12002 and LPe12004...

  • Page 2

    Appendix A “Notices” on page 17. First Edition (November 2013) © Copyright Lenovo 2013. LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant a General Services Administration “GSA” contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925.

  • Page 3: Table Of Contents

    Viewing the LEDs ..........................7 POST Conditions and Results ......................7 References ..............................9 Specifications ..........................9 FCC and Regulatory Notices ......................11 Declaration of Conformity ......................12 Laser Safety Notice ........................14 LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page iii...

  • Page 4: Introduction, Major Features, Compatibility, Prerequisites

    Fibre Channel (FC) to Peripheral Component Interconnect Express (PCIe) host bus adapters (HBAs). They feature a revolutionary design with integrated ARM-1156 cores, integrated SERDES, integrated SRAM, and external Double-Data Rate (DDRII SRAM) memory structure. The LPe12000 is a single- channel adapter. The LPe12002 is a dual-channel adapter.The LPe12004 is a four-channel adapter.

  • Page 5: Setting The Jumpers

    ID is 0x1AE5. Table 1. Jumper Settings (Port 0 on the LPe12000 - Ports 0 and 1 on the LPe12002 - Ports 0, 1, 2 and 3 on the LPe12004) PCI Identifier P0_JX (Port 0)

  • Page 6: Installing The Host Bus Adapter

    Note: The HBA comes with a standard PCIe bracket installed. A low-profile bracket is included in the box with the LPe12000, LPe12002 HBAs. (The LPe12004 will not fit in a half height slot.) The low-profile mounting bracket is shorter than the standard bracket;...

  • Page 7

    16. Secure the HBA's mounting bracket to the case with the panel screw or clip. 17. Replace the computer case and tighten case screws. The HBA is now installed in the PC and is ready for media attachment. LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 4...

  • Page 8: Attaching Media

    8.5Gb/s 0.5m – 21m OS1/OS2 – Single-mode 9 2.125Gb/s: 0.5m – 10 km .5 meters micrometer fiber with LC 4.25Gb/s: 0.5m – 10 km connectors 8.5Gb/s 0.5m – 10 km LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 5...

  • Page 9

    Figure 6: Connecting Fiber Optic Cable 2. Connect the other end of the cable to the Fibre Channel device. After the media is connected to the HBA, you are ready to apply power to the computer. LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 6...

  • Page 10: Applying Power, Viewing The Leds, Post Conditions And Results

    Fast Blink POST failure Flashing POST processing in progress Failure while functioning Failure while functioning 2 Fast Blinks 2Gb/s link rate-normal, link up 3 Fast Blinks 4Gb/s link rate-normal, link up LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 7...

  • Page 11

    Slow Blink Normal-link down or not started Slow Blink Slow Blink Off-line for download Fast Blink Slow Blink Restricted off-line mode (waiting for restart) Flashing Slow Blink Restricted off-line mode (test active) LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 8...

  • Page 12: References, Specifications

    References Specifications Table 9. LPe12000, LPe12002 and LPe12004 Specifications Parameter Range Media Interface The controller interfaces to the physical media through an FC-0 Media Interface (FC-PI compliant transceiver), and then connects through dual optical fiber LC connectors. Physical Dimensions Low-profile MD2 form factor, 6.600 inches by 2.713 inches, and accommodates both the full-height and low-profile bracket.

  • Page 13

    Table 9. LPe12000, LPe12002 and LPe12004 Specifications Parameter Range Agency Approvals for • Class 1 Laser Product per DHHS 21CFR (J) & EN60825-1 LPe12000, LPe12002 and • UL recognized to UL60950-1 2nd Edition LPe12004 • CUR recognized to CSA 22.2, No. 60950-1-07 •...

  • Page 14: Fcc And Regulatory Notices

    This is a Class A product. If this equipment is used in a domestic environment, radio interference may occur, in which case, the user may be required to take corrective action. VCCI—A LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 11...

  • Page 15: Declaration Of Conformity

    Note: Any changes or modifications not expressly approved by Emulex Corporation, including the use of non-Emulex certified optical transceivers, could void the user's authority to operate this equipment. LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 12...

  • Page 16

    LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 13...

  • Page 17: Laser Safety Notice

    Certification and Classification The LPe12000, LPe12002 and LPe12004 host adapters may contain one or more examples of a laser product known as a small form factor transceiver. This transceiver provides the physical connection to the optical cable, and its LC-style connector extends through the mounting bracket.

  • Page 18

    5.0 volts. If the power supply level rises above 5.0 volts, the small form factor transceiver cannot be guaranteed to operate correctly and could result in laser emissions that may exceed Class 1 limits. LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 15...

  • Page 19

    Copies of the certificate of conformity for any small form factor transceiver sold by Emulex can be obtained upon request from Emulex Corporation, Costa Mesa. LPe12000, LPe12002 and LPe12004 Hardware Installation Manual Page 16...

  • Page 20

    Lenovo representative for information on the products and services currently available in your area. Any reference to a Lenovo product, program, or service is not intended to state or imply that only that Lenovo product, program, or service may be used. Any functionally equivalent product, program, or service that does not infringe any Lenovo intellectual property right may be used instead.

  • Page 21

    Trademarks Lenovo, the Lenovo logo, and ThinkServer are trademarks of Lenovo in the United States, other countries, or both. Emulex, the Emulex logo, AutoPilot Installer, AutoPilot Manager, BlockGuard, Connectivity Continuum, Convergenomics, Emulex Connect, Emulex Secure, EZPilot, FibreSpy, HBAnyware, InSpeed, LightPulse, MultiPulse, OneCommand, OneConnect, One Network.

This manual also for:

Lpe12002, Lpe12004

Comments to this Manuals

Symbols: 0
Latest comments: