Section 2 - Operation; Scanning; Restoring Automatic Mode - Epson Perfection User Manual

2.1 Scanning

1. From the Add To Case screen, press the
2. On the V3 Cart, make sure the upper drawer is fully closed and the lower drawer is fully
extended.
3. Lift the scanner cover and place the original face down on the document table:
- the top of the image should be towards the back of the scanner (or the image can be
rotated later)
- the original should be aligned into the right rear corner of the document table
4. On the Scanner screen, select the type of scan:
- for a high-contrast, black and white image, push
- to retain color, shading, and details, push
5. Observe the TWAIN driver window as it goes through the following steps:
a. scanner warming up
b. preview
c. scan
6. When the scan is complete, the image will appear in the Scanner screen. If desired, push
the button to rotate the image 90 degrees.
Rotate
7. Scan additional images, if desired.
8. Click on the checkbox next to each thumbnail image to select or deselect it, and press
to save the selected images into the case.

2.2 Restoring Automatic Mode

The following procedure specifically applies to the TWAIN 5 driver supplied with the Model
1640 and 1650 scanners.
In the event that a scan brings up the manual mode screen (see Figure 16), return to automatic
mode as follows:
1. Press the Full Auto mode
2. On the screen shown in Figure 15, ensure that the manual setting for resolution is
deactivated as follows:
a. Press the right arrow button
b. If the box by Specify Resolution for Full Auto Mode is checked, click on it to remove
the checkmark.
PUB-119 Rev B.doc
Section 2 – Operation
Scanner
button. This returns to the screen in Figure 15.
to expand the lower area of the screen, if necessary.
19
button.
Scan
Scan Color
Save