Care And Cleaning; Beater To Bowl Clearance - KitchenAid Commercial Stand Mixer Instructions Manual

Bowl, stainless steel flat beater, wire
whip, and spiral dough hook may be
washed thoroughly with soap and hot
water and rinsed completely before
drying. Do not store beaters on shaft.

Beater to Bowl Clearance

Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of
the bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away
from the bowl, you can correct the clearance easily.
1. Unplug Stand Mixer or disconnect
power.
2. Place bowl lift lever in down position.
3. Attach flat beater.
4. Adjust so flat beater just clears bottom
surface of bowl when in lifted position
by turning screw counterclockwise
to raise the bowl and clockwise to
lower the bowl. Just a slight turn is all
that is required: the screw will not
rotate more than 1/4 turn (90 degrees)
in either direction. (The full range of
adjustment is 1/2 turn, or 180 degrees.)
5. Place bowl lift lever in up position
to check clearance.
6. Repeat steps 4 and 5 if necessary.

Care and Cleaning

NOTE: Always be sure to unplug stand
mixer before cleaning. Wipe stand mixer
with a soft, damp cloth. Do not use
household/commercial cleaners. Do not
immerse in water. Wipe off beater shaft
frequently, removing any residue that
may accumulate.
Raise Bowl
A
NOTE: When properly adjusted,
the flat beater will not strike on the
bottom or side of the bowl. If the flat
beater or the wire whip is so close
that it strikes the bottom of the bowl,
the beater or whip may wear.
Lower Bowl