Using The Function Button - Fujitsu ETERNUS DX80 S2 User Manual

Chapter 2 Basic Operation

2.2 Using the FUNCTION Button

Procedure
1
Press and hold the Power switch of the controller enclosure for four seconds or more.
The READY LED of the controller enclosure is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the READY
LED turning off and the POWER LED turning off, the ETERNUS DX Disk storage system power may turn
on.
2
The ETERNUS DX Disk storage system power is turned off.
The POWER LEDs on the controller enclosure and the drive enclosures are turned off.
2.2 Using the FUNCTION Button
This section explains how to use the FUNCTION button of the controller enclosure.
The following settings can be performed by using the FUNCTION button:
• Switching the Master CM to the other controller for a dual-controller type
For a dual-controller type, the controller through which the ETERNUS DX Disk storage system is set up and
operated is called the "Master CM", while the other controller is called the "Slave CM".
The single-controller type only has a "Master CM" controller.
• Restoring the factory default settings (network environment settings and firewall settings) of the LAN ports
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Power switch
Copyright 2013 FUJITSU LIMITED
Drive enclosure
Drive enclosure
Controller enclosure
39
End of procedure
P3AM-4842-12ENZ0