Fujitsu ETERNUS DX80 S2 User Manual page 129

Appendix A Event Notification Message List
A.2 Message List
Event type
code
xxx
M A3A20
M A3B20xxx
M A3C20 xxx
xxx
M A4130
xxx
M A4430
M A4A30 xxx
xxx
M A4B30
xxx
M A4C30
M E0050 nxx
M E10300 xx
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
SNMP Trap
Trap
Trap
Maintenance
No.
Info
xxx
7 A3A20 RAID Group#0
because of source disk problem
Copyback to the replaced drive is halted because an error is
found in the copy source drive.
xxx : RAID group number (hexadecimal)
xxx
7 A3B20 RAID Group#0
Copyback to the replaced drive is halted.
xxx
: RAID group number (hexadecimal)
7 A3C20 xxx RAID Group#0
Copyback to the replaced drive is retried.
xxx
: RAID group number (hexadecimal)
xxx
7 A4130 RAID Group#0
Redundant copy has not started.
xxx : RAID group number (hexadecimal)
xxx
7 A4430 RAID Group#0
processing
Redundant copy is being performed.
xxx
: RAID group number (hexadecimal)
7 A4A30 xxx RAID Group#0
processing because of source disk problem
Redundant copy to the replaced drive is halted because an
error is found in the copy source drive.
xxx
: RAID group number (hexadecimal)
xxx
7 A4B30 RAID Group#0
processing
Redundant copy is halted.
xxx : RAID group number (hexadecimal)
xxx
7 A4C30 RAID Group#0
processing
Redundant copy is retried.
xxx
: RAID group number (hexadecimal)
7 E0050 xxx WRITE BAD DATA
Writing of Bad Data (data lost identifier) occurs.
xxx
: RAID group number (hexadecimal)
7 E10300 xx PINNED DATA was created CM#
The pinned data occurs.
xx
: CM module ID (10 – 11) in which the pinned data
occurred
m
: CM number (0 – 1) in which the pinned data occurred
v
: CPU number in CM
129
Copyright 2013 FUJITSU LIMITED
Upper: Message
Lower: Description
xxx
abnormal end of Copyback processing
xxx
abnormal end of Copyback processing
xxx retry procedure of Copyback processing
xxx
start failure of Redundant Copy processing
xxx
start procedure of Redundant Copy
xxx abnormal end of Redundant Copy
xxx
abnormal end of Redundant Copy
xxx
retry procedure of Redundant Copy
m -CPU# v
Remarks
These messages are
notified when
"Rebuild/Copyback w/
o redundant" is
enabled for Error
Severity Level in the
event notification
setting.
They are not notified
during maintenance
operations.
These messages are
notified when
"Redundant" is
enabled for Error
Severity Level in the
event notification
setting.
They are not notified
during maintenance
operations.
This message is
notified when "Bad
data" is enabled for
Error Severity Level in
the event notification
setting.
This is not notified
during maintenance
operations.
This message is
notified when
"Pinned data" is
enabled for Error
Severity Level in the
event notification
setting.
This is not notified
during maintenance
operations.
P3AM-4842-12ENZ0