Storage; Winter Storage; Service - Husqvarna MZ61 Operator's Manual

Winter Storage

The machine should be readied for storage at the end of the
mowing season or if it will not be in use for more than 30 days.
Fuel allowed to stand for long periods of time (30 days or
more) can leave sticky residues that can plug the carburetor
and disrupt engine function.
Fuel stabilizers are an acceptable option as regards to the
sticky residues that can occur during storage.
Add stabilizer to the fuel in the tank or in the storage container.
Always use the mixing ratios specified by the manufacturer
of the stabilizer. Run the engine for at least 10 minutes after
adding the stabilizer so that it reaches the carburetor. Do not
empty the fuel tank and the carburetor if you have added
stabilizer.
WARNING! Never store an engine with fuel in the
tank indoors or in poorly ventilated spaces where fuel vapor
can come in contact with open flames, sparks, or a pilot
light such as in a boiler, hot water tank, clothes dryer, etc.
Handle the fuel with care. It is very flammable and can
cause serious personal injury and property damage. Drain
the fuel into an approved container outdoors and store far
away from open flame or sources of ignition. Never use
gasoline for cleaning. Use a degreaser and warm water
instead.
32

STORAGE

To ready the machine for storage:
1. Thoroughly clean the machine, especially under the
mower deck. Touch up damage to the paint and spray
a thin layer of oil on the underside of the mower deck to
avoid corrosion.
2. Inspect the machine for worn or damaged parts and
tighten any nuts or screws that may have become loose.
3. Change the engine oil; dispose of properly.
4. Empty the fuel tanks or add a fuel stabilizer. Start the
engine and allow it to run until the carburetor is drained of
fuel or the stabilizer has reached the carburetor.
5. Remove the spark plug and pour about a tablespoon of
engine oil into the cylinder. Turn over the engine so that
the oil is evenly distributed and then refit the spark plug.
6. Lubricate all grease zerks, joints, and axles.
7. Remove the battery. Clean, charge, and store the battery
in a cool place, but protect it from direct cold.
8. Store the machine in a clean, dry place and cover it for
extra protection.

Service

When ordering spare parts, please specify the purchase year,
model, type, and serial number.
Always use genuine Husqvarna spare parts.
An annual check-up at an authorized service workshop is a
good way to ensure that your machine performs its best the
following season.
32