Style 2 - Built-In Outdoor Grill Installation - KitchenAid KFRS271T Installation Instructions And Use & Care Manual

2. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
3. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
4. The igniter battery is not factory installed. A 1.5 volt "D" size
alkaline battery is located in the accessory box on the grill
grate. Install battery at this time following the instructions in
the "Replacing the Igniter Battery" section.
5. Go to "Check and Adjust the Burners" section.
WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack grill. Remove all packaging materials and remove grill
from carton.
Move grill close to desired outdoor location.
Open the hood.
Remove Packaging Material Inside the Grill
1. Cut the tiedowns holding the grates together.
2. Remove rotisserie skewer (on some models), warming shelf
and grill grates from inside the grill and remove packaging
material.
3. Remove foam block and wrap from inside the grill.
A
A. Foam block
B. Foam wrap
4. Replace the grill grates.
14
B

Style 2 - Built-In Outdoor Grill Installation

B
Plug in Grill
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3-prong outlet.
5. Place warming shelf on brackets as shown.
A
A. Warming shelf brackets
B. Warming shelf
6. Dispose of/recycle all packaging material.
Make Gas Connection
NOTE: If grill has been converted to LP gas, follow instructions in
"LP Gas Conversion" at the end of this section.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.
Natural Gas Use
This installation must conform with local codes and ordinances.
In the absence of local codes, installations must conform with
either the National Fuel Gas Code ANSI Z223.1 -latest edition, or
CAN/CGA-B149.1 Natural Gas and Propane installation code.
B
A