Table of Contents INTRODUCTION DESCRIPTION AND FEATURES DESIGN AND PERFORMANCE WIRELESS CONNECTION INCLUDED ITEMS CONTROLS AND CONNECTIONS ONYX TOP PANEL CONTROLS ONYX REAR PANEL CONNE CTIONS AND CONTROLS SPEAKER PLACEMENT CONNECTIONS POWER CONNECTIONS SOURCE OPTIONS WI-FI CONNECTION BLUETOOTH CONNECTION WPS CONNECTION...
Power Button • The built-in rechargeable battery offers up to 6 continuous hours of This button when pressed turns the HK Onyx ON or OFF and has an LED to indicate the playtime. power mode. The three power modes are: •...
This section helps you understand how to connect your device correctly to a power Wi-Fi source, and different input sources. This button is used to connect your HK Onyx to your Wi-Fi network. The use of the button Power Connections depends on the set up method of your system.
The iPhone, iPad or iPod Touch will then share Wi-Fi settings with the Harman Kardon Onyx and Onyx will be connected to your Wi-Fi network. This takes at least 40 seconds. Once the Harman Kardon Onyx is connected to the network, the Wi-Fi LED will light constant white and a sound prompt will be heard.
Cancel and enter the password again without any mistake. You can change the name of the speaker for easy The Harman Kardon Onyx will then attempt to connect to your Wi-Fi network. If the identification using the H/ K Remote app.
LED Indications Connecting through DLNA The LEDs present on the top panel of HK Onyx indicates the status of the speaker unit. Refer the table below to get a fair idea on the speaker LED indications. DLNA in the HK Onyx helps in sharing audio data over a home network and stream audio.
Onyx Troubleshooting Troubleshooting If your Harman Kardon Onyx is not performing the way you think it should, check if the problem is covered in this section before calling your dealer or contacting a Harman Kardon representative. Problems Solutions There is no sound coming from the HK Onyx •...
Onyx Specifications Specifications Frequency Range 2402MHz – 2480MHz Frequency Response 60Hz – 20kHz No of channels Transducers 2 X 3 woofers, 2 X ¾ tweeters, 2 passive radiators Bi-amplification 4 X 15W Maximum SPL 95dB @ 1m Power Requirement 100 – 240 V AC, 50/60 Hz Power adaptor 19V, 3.4 A...