Installation
DewPro with Display
Assembly
Replacing the Display
The Optional Display/User Interface (Option G)
If the DewPro is equipped with an optional display/user interface,
follow the procedure below to access the buttons.
Figure 4-1: DewPro with Display
1. Unscrew and remove the protective lid from the top of the DewPro
(as shown in Figure 4-1 above), exposing the display module
below. The buttons V, H, + and - are now accessible.
2. The display unit snaps onto the printed circuit board, resting on
four posts. When removing the display, push one post to the
outside, using a small screwdriver, and pull the display out.
3. Then unplug the display cable.
November 2005
4-1