Replacing the Lamp
The life span of the lamp is about 4000 hours if Power Consumption in the Signal menu is set
to Normal, and about 5000 hours if Power Consumption is set to ECO.
You can check how long the lamp has been used as described on page 49. If the number
shown is close to the limit, make sure you have a spare lamp handy.
Note: Turn off this product when not in use to prolong the life of the projector.
It's time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The lamp warning light flashes orange.
Replace the lamp
Caution: If you continue to use the lamp after you see the replacement indicators, the lamp is more
likely to break.
You can purchase a new lamp (part # V13H010L56) from an Epson authorized reseller. To
find the nearest reseller, contact your nearest Epson sales office as describe in XXX."Where To
Get Help" on page 65
Be sure to read the safety instructions before replacing the lamp. See page 11.
Follow these steps to replace the lamp:
1. Press the
button on the control panel or the
the projector off. When you hear two short beeps, disconnect the power cable.
2. If the projector has been on, let it cool for at least an hour.
Warning: Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully
to avoid injury.
Lamp warning light
appears on the screen when you start projecting.
button on the remote control to turn
Caring for Your Projector