Network Card Menu - Lexmark CS310n User Manual

Understanding the printer menus
Use
Network Buffer
Disabled
Auto
3KB to [maximum size allowed]
Mac Binary PS
On
Off
Auto
Standard Network Setup OR
Network [x] Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk

Network Card menu

To access the menu, navigate to either of the following:
• Network/Ports > Standard Network > Standard Network Setup > Network Card
•
Network/Ports > Network [x] > Network [x] Setup > Network Card
Use
View Card Status
Connected
Disconnected
View Card Speed
Network Address
UAA
LAA
To
Set the size of the network input buffer.
Notes:
•
Auto is the factory default setting.
•
The value can be changed in 1‑KB increments.
•
The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
•
To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
•
Auto is the factory default setting.
•
Off filters print jobs using the standard protocol.
•
On processes raw binary PostScript print jobs.
Display and set the printer network settings.
Note: The Wireless menu appears only when the printer is connected to a wireless
network.
To
View the connection status of the network card.
View the speed of an active network card.
View the network addresses.
62