Disabling / Enabling Time Periods - Honeywell CM927 User Manual

i. To exit the programming mode move the slider switch to the desired operating
mode - AUTO, MAN or OFF. Note: To run the adjusted program select the AUTO
mode.
Note: If the unit is left in programming mode for more than 10 minutes without
the slider being moved or any buttons pressed, 'MOVE THE SLIDER' will be
displayed. Press a button to finish programming the thermostat or move the
slider to select the desired operating mode.

Disabling / Enabling Time Periods

The thermostat has 6 periods each day that can be programmed, but you may not
need all of these switch points for your heating requirements. Therefore, any period
from 2 to 6 can be disabled or enabled as follows:
To disable time periods:
Go to the desired period (
position, then using the
correct period is highlighted with the flashing square symbol. Press and hold the
button for at least 2 seconds and the display will indicate the period has been
removed from the program.
To enable time periods:
Navigate to the disabled period by moving the slider switch to the PROG position,
then using the
displayed. Press and hold the
be displayed for a moment before returning to normal programming mode.
to ) by moving the slider switch to the PROG
2 6
, and DAY buttons to navigate, ensuring the
or and DAY buttons. Once selected 'DISABLED' will be
button for at least 2 seconds and 'ENABLED' will
pRoGRAMMING THE CM927
7