Basic Operations; Functions Of The Buttons On The Front Panel - Kenwood DNX7330BT Instruction Manual

Return to the Top page

Basic Operations

B
asic Operations
F
unctions of the Buttons on the Front Panel
DNX7330BT/DNX7330BTM
2 3 5
1 4 6
NOTE
• The panels shown in this guide are examples used to provide clear explanations of the operations. For this reason,
they may be different from the actual panels.
• In this manual, each model name is abbreviated as follows.
DNX7330BT, DNX7330BTM:
If above icon is showed, read the article applicable to the unit you use.
How to insert an SD Card
0
1) Press < > button for 1 second.
8
The panel fully opens.
2) Hold the SD card as the illustration in the right
and insert it into the slot until it clicks.
● To eject the card:
Push the card until it clicks and then remove your finger
from the card.
The card pops up so that you can pull it out with your
fingers.
6 6
10
11
7 8 9
Labelled
side
0
Number Name
fi (Reset)
• If the unit or the connected unit fails to operate properly, the unit
1
returns to factory settings when this button is pressed (P.115).
• If the Security Indicator (SI) function is turned on, this indicator flashes
when the vehicle ignition is off (P.85).
ATT • Switches attenuation of the volume on/off.
2
• Pressing for 1 second turns the screen off.
∞, 5 (Vol)
Adjusts volume.
3
AUD • Displays Graphic Equalizer screen (P.101).*
4
• Pressing for 1 second switches camera view display on/off.
NAV • Displays the navigation screen.
5
• Pressing for 1 second switches AV out sources.
MENU • Displays the Top Menu screen (P.16).
6
• Pressing for 1 second turns the power off.
• When the power off, turns the power on.
TEL • Displays the Hands Free screen (P.68).
7
• Pressing for 1 second displays the Voice Recognition screen. (P.76)
0 (Eject)
• Ejects the disc.
8
• When the panel is opened, pressing closes the panel and pressing for 1
second ejects the disc forcibly.
• When the panel is closed, pressing for 1 second fully opens the panel to
the location of the SD card slot.
Remote Receives the remote control signal.
9
Sensor
Disc insert A slot to insert a disc media.
10
slot
SD card slot An SD card slot for upgrading the map. For how to upgrade the map, refer
11
to the instruction manual of the navigation system.
* The display may not switch to the Graphic Equalizer screen in some conditions.
Return to the Top page
Basic Operations
Motion
7