Table of Contents
Advertisement
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned according
to the following schedule:
Vacuum Cleaner Use
HEAVY
-
(used daily)
MODERATE
-
(used 2-3 times/week)
LIGHT -
(used I time/week)
Clean Agitator
every week
every month
every 2 months
IMPORTANT
Disconnect
vacuum cleaner from
electrical outlet. Check and remove hair,
string and tint build-up frequently
in the
Power-Mate ® agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
AGITATOR ASSEMBLY
_ End Cap
Belt Path-
Brush Unit
End Cap-
17
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over belt
path,
NOTE: See
PARTS AND
FEATURES
for Bett num-
bero
\_\-"
-Belt
\
_T
\
Path
Agitator
End Cap
2. Place agitator
assembly back
into Power-
Mate _,
3. Reinstall
agitator cover
by lining up
the front tabs
and slots and
rotating
downward
until the
Iatches snap
into place.
Agitator Cover
Tabs
4. Line up
front of cover
and base°
Rest cover
on front edge
of base as
shown.
Cover
Base
5. Rotate cover
back° Press cover
firmly until side and
rear tabs snap into
place.
6. Turn Power-Mate®upside down and
replace two (2) cover screws,
Advertisement
Table of Contents
