Reversing The Door Swing - GE Monogram ZDBC240 Owner's Manual

To remove the door:
To reverse
the door
Rotate the door:
Handle will be on right side of door,
hinges will go on the left.
To reinstall the door:
10. Put remaining case hinges in bag for
Note: Verify that door is on straight and
screws are tightened. If not, the door
will sag.
Position new nameplate:
Remove the old nameplate and stick the
new Monogram nameplate on the door
using the template included.
1. Remove 2 screws holding toekick.
2. Remove hinge plug cover on top left
side of cabinet.
3. Flatten the shipping carton to use as
a pad for the door.
4. Remove the 3 screws holding the top
case hinge.
5. Lift off case hinge, it will not be used
again.
6. Lift door off bottom case hinge.
7. Remove bottom case hinge and cam
riser.
8. Remove fill plug and screw on top
right side of door.
9. Remove door hinge, door stop and
screw from bottom right side of door.
1. Install bottom case hinge from kit and
cam on the left side of the unit.
2. Install door hinge and door stop to
bottom left of door.
3. Install fill plug on top left of door.
4. Place door on bottom case hinge.
5. Install top case hinge from kit on top
left of cabinet.
6. Install hinge plug cover on top right
of unit.
7. Move plug on toekick to opposite side.
8. Install toekick. Verify that spacers are
attached to screw holes.
9. Install Monogram nameplate on door.
possible future use.

Reversing the Door Swing

Beverage Center
Install
3 Hinge
Screws
Hinge
Pin
Remove
Top Hinge
Cam
Riser
Remove
Hinge
13