Chassis Intrusion Switch; Removing The Front Led/Switch Bracket; Removing The Chassis Intrusion Switch - NEC POWERMATE CT 815 Service And Reference Manual

Chassis Intrusion Switch

Remove the chassis intrusion switch from the rear edge of the chassis as follows.
Remove the system cover (see "Removing the Cover").
1.
Unplug the chassis intrusion switch cable from its header on the system board.
2.
Press together the tabs that hold the chassis intrusion switch to the chassis (see the
3.
following figure).
Once the tabs are free, gently push the chassis intrusion switch through its cutout in the
4.
chassis wall.
Set the intrusion switch aside.
5.
3-30 Disassembly and Reassembly

Removing the Front LED/Switch Bracket

A – Front LED/Switch Bracket

Removing the Chassis Intrusion Switch

A – Tab B – Chassis Intrusion Switch