Replacing The Light Bulbs - GE r10965v-1 Owner's Manual

Fresh food Setting the controls to OFF does not remove
power to the light circuit.
compartment—
upper light 1 Unplug the refrigerator.
2 The bulbs are located at the top of the
3 To remove the light shield, press in on the
Fresh food Setting the controls to OFF does not remove
power to the light circuit.
compartment—
lower light
This light is located above the top pan.
1 Unplug the refrigerator.
2 Remove the convertible meat drawer control
3 Lift the light shield up and pull it out.
4 After replacing the bulb with an appliance
5 Plug the refrigerator back in.
Freezer Setting the controls to OFF does not remove
power to the light circuit.
compartment
1 Unplug the refrigerator.
2 Remove the shelf just above the light shield.
3 To remove the light shield, press in on the
Dispenser Setting the controls to OFF does not remove
power to the light circuit.
1 Unplug the refrigerator.
2 The bulb is located on the dispenser under
22
compartment, inside the light shield.
On some models, a screw at the front
of the light shield will have to be removed.
tabs on the sides of the shield and slide
forward and out.
knob by pulling straight out.
bulb of the same or lower wattage, replace the
shield and the knob.
(The shelf will be easier to remove if it is
emptied first.) On some models, a screw at
the top of the light shield will need to be
removed.
sides, and lift up and out.
the control panel. Remove the light bulb by
turning it counterclockwise.

Replacing the Light Bulbs

Stainless Steel Refrigerator
4 After replacing the bulb with an appliance
bulb of the same or lower wattage, replace
the light shield and screws (on some models).
When replacing the light shield, make sure
that the tabs at the back of the shield fit into
the slots at the back of the light shield housing.
5 Plug the refrigerator back in.
4 Replace the bulb with an appliance bulb of
the same or lower wattage, and reinstall the
light shield. When reinstalling the light shield,
make sure the top tabs snap securely into
place. Replace the screw (on some models).
5 Reinstall the shelf and plug the refrigerator
back in.
3 Replace the bulb with a bulb of the same size
and wattage.
4 Plug the refrigerator back in.
Tabs