Displaying Technical Information; Using Mheg Application (Uk Only); Screen Saver; Common Interface - Pioneer PDP-436SXE Operating Instructions Manual

Enjoying DTV broadcasts

Displaying technical information

Use this function to check the hardware/software version
number.
1
Repeat steps 1 to 4 provided for "Using Auto Update".
2
Select "Technical Information" ( /
NOTE
• You can select "DTV Setup" only when watching DTV
channels.

Using MHEG application (UK only)

Some stations bring you programmes with the MHEG
(Multimedia and Hypermedia Expert Group) application
encoded, letting you experience DTV interactively.
When provided, the MHEG application will start when you
press any of the colour buttons or m.
NOTE
• This function is not available when subtitle is activated (see
page 33).
• You can select "DTV Setup" only when watching DTV
channels.

Screen Saver

The screen saver automatically starts when no operation is
performed for 3 minutes while receiving DTV radio channels.
NOTE
• While the screen saver is active, you can perform the
following operations:
• Press TV/DTV to switch to analogue TV.
• Press any other button to switch to the normal radio
channel screen.
• Programme Timer is active while the screen saver is
displayed.

Common Interface

To receive scrambled DTV signals you will need a CA module
and a smart card provided by the service provider.
Although CA module types may vary depending on the
manufacturer, each one of the CA modules supports a certain
then ENTER).
kind of encryption system. Your Plasma Display supports CA
modules which are made to work with the DVB standard.
Contact a service provider for the right type of CA module.
Please note that a smart card may only be valid for a single
service provider and due to this, a specific range of channels.
• CA modules and smart cards are neither supplied nor
optional accessories from PIONEER.
After inserting a card, leave it in the slot permanently. Do not
remove it from the terminal unless asked to do so. For instance,
your card has to be in the slot when your service provider wants
to download new information to the smart card.

Inserting a CA Card

Common Interface card slot is located at the rear of the Plasma
Display.
1
2
NOTE
Hold the tab of the slot cover on the rear of the Plasma
Display, and remove the cover while releasing the tab's
latch.
Insert the specified CA Module into the Common Interface
slot as far as it will go.
09
Tab
39
En