Connecting Control Cords; About Sr - Pioneer PDP-434HDE Operating Instructions Manual

Enjoying through External Equipment

Connecting control cords

Connect control codes between the Media Receiver
and other PIONEER equipment having the t logo. You
can then operate the connected equipment by sending
commands from its remote control unit to the remote
control sensor on the Media Receiver.
After the CONTROL IN terminals have been connected,
the remote control sensors on the connected equip-
ment do not accept commands from the remote
control units. Face the remote control units to the
remote control sensor on the Plasma Display when
operating the connected equipment.
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making
control cord connections.
Media Receiver (rear view)
I N OUT
CONTROL
SERVICE ONLY
INPUT 1 INPUT 1
i / o link.A
SELECT
INPUT
2 3
INPUT 2 INPUT 2
I N OUT
CONTROL
INPUT 3
SUB WOOFER
OUTPUT
COMPONENT VIDEO
Y P P
B R
MONITOR
OUTPUT
VIDEO R-AUDIO-L
INPUT 3 INPUT 3 S- VIDEO

About SR+

The CONTROL OUT terminal on the rear of the Media
Receiver supports SR+ that allows linked operations
with a PIONEER AV receiver. SR+ presents functions
such as the input switch linkage operation function and
the DSP surround mode display function. For more
information, see the user's manual for the PIONEER AV
receiver supporting SR+.
• While in connection through SR+, the volume on
this system is temporarily minimized.
AC INLET
BLACK
WHITE
SYSTEM CABLE
The control cables (commercially available) are monau-
ral cables with mini plugs (no resistance).
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
10
59
En