Anchoring - Yamaha 212SS Owner's Manual

anChorinG

WARNING
always anchor
anchoring from the stern will make
the boat unsteady. a strong cur-
rent can pull a stern-anchored boat
underwater.
Select an anchor appropriate for your
boat and water conditions. A "danforth"
(or fluke) type anchor is suitable for
most applications; your dealer can help
you choose an anchor.
1) Make sure the anchor line is secure-
ly tied to the anchor and to the bow
eye.
2) Move the boat to the spot where you
want to lower the anchor, heading
the boat into the wind or current.
Stop the boat, then lower the anchor
until it hits bottom.
3) While keeping tension on the line,
slowly back up the boat until you
have let out line that is 4 to 6 times
the depth of the water. For example,
if you are anchoring in 10 feet of
water, let out 40 to 60 feet of line.
Secure the line.
from the bow.
4) Pull on the line to be sure the
anchor is holding. Also, periodically
check your boat's position against
the shoreline to make sure it is not
drifting and dragging the anchor.
Reset if necessary.
5) To pull in ("weigh") the anchor, start
the engines and move forward,
keeping tension on the line as you
pull it in. When the anchor line is
straight up and down, pull hard to
lift the anchor from the bottom mate-
rial.
6) If the anchor is stuck on the bottom,
try this: Let out a few feet of anchor
line and secure the line to the boat,
again. Slowly maneuver the boat
around the anchor until the anchor
pulls loose. Keep the line taut during
this procedure.
3-25
O
PERATION
3