Fax Multi Tx Report - Canon 3245 Troubleshooting Manual

Fax Multi TX Report

This report is used to check whether documents were sent successfully to the intended destinations
when a sequential broadcast transmission was performed.
If a sequential broadcast transmission is performed when Fax TX Report is set to 'On' , a Fax Multi TX
Report is printed automatically. (See e-Manual > Send/Fax.)
•
This mode is available only if the optional FAX Board is installed.
•
You can also print a Fax Multi TX Report with an image of the sent original attached to it. (See e-Manual > Send/
Fax.)
JOB NO.
The four digit number, that is automatically assigned when the document is accepted for sending, is printed.
DEPT. ID
If Department ID Management is set, the Department ID is printed.
PGS.
The number of pages that were sent is printed.
TX/RX INCOMPLETE
If a transmission is incomplete, the fax number and the name of the destination are printed. If there is no
applicable destination, "_ _ _" is printed.
TRANSACTION OK
The fax number and the name of the destination of a completed transmission are printed. If there is no
applicable destination, "_ _ _" is printed.
ERROR
If an error in transmission occurs, the fax number and the name of the destination are printed. If there is no
applicable destination, "_ _ _" is printed.
Sample Reports
4-11
4