Chain Dialing; Storing A Pause In Memory; Replacing The Batteries - RCA 1223 User Manual

Chain Dialing

Chain dialing allows you to dial a sequence of stored numbers from separate
memory locations.
For example
Local access number
Long distance company
Authorization code ID
Long distance phone number
1. Select the line you want to use by pressing the corresponding line button.
2. Lift the handset,or press Speaker for speakerphone
3. Press Memory A button.
4. Press Memory B button.
5. Press Memory C button.

Storing a Pause in Memory

The Redial/Pause button has dual functionality and becomes a pause button
when the Store button is pressed first.It is valid only when storing a number
into memory locations. Use the Redial/Pause button to insert a pause when a
delay is needed in an automatic dialing sequence. For example, when you
must dial a 9 to get an outside line or when you enter codes to access your
long distance company.
You may need to adjust the length of the pause duration. It can be adjusted
from 1 to 9 seconds in length. The default setting is 4 seconds.
1. Press the Store button.
2. Press the Redial/Pause button. The current pause time displays.
3. Press the Review  or  buttons to scroll the pause time, or press the 1 to
9 key for one second to nine seconds respectively (i.e.; 1 = one second, 2 =
two seconds).
4. Press the Store button to save.

Replacing the Batteries

IMPORTANT: You will have approximately 90 seconds to replace
the batteries before the memories stored are lost . Please read the
instructions before replacing the batteries and have the batteries
ready to be inserted beforehand.
1. Press down and out on the snap tab located on the top of the mounting
bracket.Lift the bracket off.
2. Release latch on battery compartment and remove cover.
Memory location
A
B
C
24