Charging The Battery; Li-Ion Battery Pack; Ni-Cd Battery Pack - Panasonic EY0L10 Operating Instructions Manual

Read the operating
instructions before use.
For outdoor use only.
. CHARGING THE
BATTERY

Li-ion Battery Pack

NOTE:
Your battery pack is not fully charg-
ed at the time of purchase. Be sure
to charge the battery before use.
Battery charger (EY0L10)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
. Slide the battery dock cover back to
allow insertion of the lithium ion bat-
tery pack.
● Verify that the cover is locked
securely in place.
. Insert the battery pack firmly into the
charger.
To AC
outlet
4. During charging, the charging lamp
will be lit.
When charging is completed, an inter-
nal electronic switch will automatically
be triggered to prevent overcharging.
• Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
The orange standby lamp will be lit
until the battery cools down.
Charging will then begin automati-
cally.
5. The charge lamp (green) will flash
slowly once the battery is approxi-
mately 80% charged.
6. When charging is completed, the charg-
ing lamp will start flashing quickly in
green color.
7. When in any of the conditions that
battery pack is too cool, charging
takes longer to fully charge the bat-
tery pack than the standard charging
time.
Even when the battery is fully charg-
ed, it will have approximately 50% of
the power of a fully charged battery at
normal operating temperature.
8. If the power lamp does not light
immediately after the charger is
plugged in, or if after the standard
charging time the lamp does not go
off, consult an authorized dealer.
9. If a fully charged battery pack is
inserted into the charger again, the
charging lamp lights up. After sever-
al minutes, the charging lamp may
flash quickly to indicate the charging
is completed.

Ni-Cd Battery Pack

NOTE:
When you charge the battery pack
for the first time, or after prolonged
storage, charge it for about 4
hours to bring the battery up to full
capacity.
Battery charger (EY0L10)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
. Slide the battery dock cover back to
allow insertion of the Ni-Cd battery
pack.
● Verify that the cover is locked securely
in place.
. Insert the battery pack firmly into the
charger.
- 5 -