Hinge Adjustment - Viking VCSB5421 Installation Manual

Hinge Adjustment

5
2
Remove four side screws and remove unit top.
7
1
Attach one 2x4 to wall stud (refer to dimensions page
Replace unit top. Replace four side screws.
8b
Wall
2 x 4
Refrigerator
If needed, depending on cabinet and depth,
attach second 2x4 to first 2x4. NOTE: Make sure power switch is in the "On" Position.
28
6
Front of unit
1 3
Loosen the four hinge screws. Adjust door.
Retighten four hinge screws.
8a
Wall
2 x 4
Refrigerator
for exact location).
9
Plug in power cord to verify operation.
10a
Place unit within 3" of being flush with cabinets.
NOTE: To avoid cabinet damage, place cardboard
between cabinets and unit. When moving unit, do not
crimp, kink or crush water supply line.
11
Pull supply tubing forward under unit.
NOTE: DO NOT use plastic water lines.
13
Connect supply tube to water valve using
a 1/2" wrench. NOTE: DO NOT overtighten.
29
10b
Carefully move unit until semi flush with cabinet
(depending on unit).
12
Flush water line by running two quarts of water
into a bucket. Turn water off.
14
Turn on water supply and check for leaks.