Sun joe CJ601E Operator's Manual page 7

Assembly
1. Remove all parts from package.
2. Check all the parts against the list in the manual. If any
parts are damaged or missing do not use the wood
chipper/shredder until the part is repaired or replaced.
Call our customer service help line at 1-866-766-9563
for assistance.
3. Assemble the wheel axle to the stand assembly; put the
spacer onto the axle; insert the wheels on the axle, then
attach washer and lock nut to the axle with the supplied
wrench to secure. (Fig. 2 and Fig. 3)
Fig. 2
Fig. 3
4. Press the wheel covers into the wheels to cover the ends
of the axles. You may use a hammer to seat them securely
over the axles. There may be some clearance between the
wheel and the wheel cover, it is not necessary to press it to
the bottom. (Fig. 4 and Fig. 5)
Fig. 4
Fig. 5
5. Turn the main body upside down, insert the two ends of
the stand assembly into the housing, align the holes on the
housing and stand assembly, insert the four washers onto
the screws (A) and install into the stand assembly. (Fig. 6
and Fig. 7)
Fig. 6
Fig. 7
washer
7
(A) Screw