Cleaning And Maintenance - Zanussi ZDC37200W User Manual

Drying cycle complete / removing laundry
Once the drying cycle is complete, the LED An-
ti-crease/End is on as well as warning LED's:
Filter and Tank. If the Buzzer button has been
pressed, an acoustic signal sounds intermittent-
ly for about one minute. Remove the laundry:
1. Open door.
2. Remove visible fluff from the fluff filters. It is
best to use a damp hand for this purpose.
(see chapter: Maintenance and cleaning)
3. Remove laundry.
4. Turn the programme selector to

Cleaning and maintenance

Cleaning fluff filters
The filters collect all the fluff which accumulates
during drying. To ensure that the dryer works
perfectly, the fluff filters (fine filters and fluff fil-
ters) must be cleaned after each drying cycle.
Caution! Never operate the dryer without
fluff filters or with damaged or blocked fluff
filters.
II
I
2 3
5 6
10
Important! after each drying cycle:
- clean the fluff filters
- drain the water reservoir
(see chapter: Maintenance and cleaning)
5. Close the door.
around 30 minutes. The drum rotates at inter-
vals during this phase to protect the laundry
from creases. The laundry can be removed at
any time during the anti-crease phase.
off.
Clean the door seal
Wipe the door seal with a damp cloth immedi-
ately after the drying cycle has finished.
Emptying the water reservoir
Empty the water reservoir after every drying cy-
cle.
1
I
4
7
II
foodstuffs.
Press the Start/Pause button to continue the
drying cycle.
The drying cycles are automatically fol-
lowed by an anti-crease phase which lasts
Caution! The condensed water is not
suitable for drinking or for preparing
If the programme has been interrupted as a
result of the water reservoir being full:
www.zanussi.com