Installation Instructions; The Refrigerator; Before You Begin - GE 200D2463P002 Owner's Manual & Installation Instructions

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
In Canada, call 1.800.361.3400

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at www.GEAppliances.com (in
Canada at www.geappliances.ca) or from Parts and
Accessories, 800.626.2002 (in Canada 1.888.261.3055).
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Install it on a floor strong enough to support it fully
loaded.
Save these
Observe all
Be sure to leave these
Keep these instructions
)
or
Visit our Website at:
www.geappliances.ca
or
Visit our Website at:
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections:
• Sides 1/8" (4 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
If the refrigerator is against a wall on either side, allow
a 1/8" (3 mm) door clearance.
ROLLERS
The rollers have 3 purposes:
s
Rollers adjust so the doors close on their own when
opened about 45°.
s
Rollers adjust so the refrigerator is firmly positioned
on the floor and does not wobble.
s
Rollers allow you to move the refrigerator away from
the wall for cleaning.
To adjust the rollers:
Remove the base grille by
positioning hands as shown.
Rotate the bottom of the
grille outward until the clips
snap out.
Pull the grille away from the
refrigerator.
Using a screwdriver, turn
the two front roller
adjusting screws clockwise
to raise the refrigerator,
counterclockwise to lower it.
Replace the grille so the
notch in the grille will fit
around the bottom door
hinge.
Tilt the top of the grille
toward the refrigerator and
insert the long metal clips
into the top of the oval
openings at the bottom of

the refrigerator.

Rotate the bottom of the
grille toward the refrigerator
until it snaps into place.
13
Refrigerator
Models 22 and 25
www.GEAppliances.com