Replacing The Light Bulb - GE 197D4613P004 Owner's Manual And Installation

Care and cleaning.

Replacing the light bulb.

Light Shield
Screw
8
In the Event of a Power Failure
If the power fails, open the door as
infrequently as possible to maintain
the temperature. A gradual rise in
temperature should not have any
adverse effect on the wine.
If it is extremely hot, you may want to
unload the wine from the beverage
center/wine chiller and move the wine
to a cooler location until power is restored.
Preparing to Move
Unload the wine, then secure the racks by
taping them in place to prevent damage.
Unplug the beverage center/wine chiller.
Remove any beverages and shelves as needed for access.
The light bulb is located behind a light shield in the ceiling of the
beverage center/wine chiller near the back. To remove the light
shield, remove the screw on the right side of the light shield.
Pull down on the back of the light shield to release the two front tabs.
Unscrew the light bulb from the socket.
Replace with a 15 watt, 120 volt bulb. This type of bulb is available
at most hardware and automotive parts stores.
WARNING:
damage the electronic controls on the beverage center/wine chiller.
Reinstall the light shield.
Replace the top shelf and beverages.
Plug in the beverage center/wine chiller.
The controls may maintain your
temperature settings when the power
has been restored. If your settings are not
correct, reset according to the Control
Settings section.
Be sure the beverage center/wine chiller
stays in an upright position during the move.
Using a bulb rated higher than 15 watts may