Oven - Care And Cleaning; Sponge - AEG 47036IU User Manual

32 www.aeg.com

OVEN - CARE AND CLEANING

WARNING!
Refer to "Safety information"
chapter.
• Clean the front of the appliance with a
soft cloth with warm water and cleaning
agent.
• To clean metal surfaces, use a usual
cleaning agent
• Clean the oven interior after each use.
Then you can remove dirt more easily
and it does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all oven accessories after each
use and let them dry. Use a soft cloth
with warm water and a cleaning agent.
• If you have nonstick accessories, do not
clean them using aggressive agents,
Removing the shelf supports
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid with telescopic runners:
The retaining pins on the tele-
scopic shelf runners must point to
the front!
2
1
sharp-edged objects or a dishwasher. It
can destroy the nonstick coating.
Stainless steel or aluminium ap-
pliances
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean
the oven control panel with the
same precautions.
SHELF SUPPORTS
You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
CAUTION!
Make sure that the longer fixing
wire is in the front. The ends of
the two wires must point to the
rear. Incorrect installation can
cause damage to the enamel.