Ec Declaration Of Conformity - Makita MLT100 Instruction Manual

secure it at 45° bevel angle. Carefully lay the tool on itself
backward. Then loosen the brush holder cap. Remove the
worn carbon brushes, insert the new ones and secure the
brush holder caps. (Fig. 43)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Rip fence
• Miter gauge
• Wrench 24
• Hex wrench 5
• Joint (for connecting to dust collector)
• Stand set
For European countries only
Noise
The typical A-weighted noise levels are
Sound pressure level (L
Sound power level (L
Wear ear protection
These values have been obtained according to EN61029.
EC-DECLARATION OF CONFORMITY
Model; MLT100
We declare under our sole responsibility that this product
is in compliance with the following standards of
standardized documents; EN61029, EN55014, EN61000
in accordance with Council Directives, 2004/108/EC,
98/37/EC.
Certificate of adequacy of the technical file with respect to
98/37/EC having been obtained from the following notified
body:
Tomoyasu Kato
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
): 92 dB (A)
pA
): 105 dB (A)
WA
CE 2007
Director
ENG040-2
ENH018-1
13