Image Transfer Settings; For Http Connection - Sanyo VA-80LAN Instruction Manual

IMAGE TRANSFER SETTINGS

■ For HTTP connection

When you want to record or play the video in HTTP mode, use the separately ordered "VA-SW3050"
recorder/player software. The recording configuration will be made on the VA-SW3050 screen.
When the alarm settings are configured on "VA-SW3050", the HTTP mode is automatically selected in
the [IMAGE TRANSMISSION] setting and the FTP mode cannot be used.
1 IMAGE TRANSMISSION
Set the image transfer mode to "HTTP".
2 LIVE/NORMAL RECORD
Sets the image conditions as well as
activates/deactivates the voice recording for
live video and normal recording.
• RESOLUTION
• QUALITY
• AUDIO
Note:
When the [AUDIO INPUT] setting on the
[AUDIO SETTINGS] screen is configured to
"OFF", [AUDIO] cannot be configured.
3 ALARM
1 Sets the image conditions as well as
activates/deactivates the voice recording
for alarm recording.
• RESOLUTION
• QUALITY
• AUDIO (see the "Note" above.)
2 Select the [BUFFER SIZE] option for
specifying the buffering capacity for
recording each alarm image. According to
the value you select, perform the following
settings:
English
1
2
1
3
2
4
When the [BUFFER SIZE] setting is set from
"0.5MB to 8MB"
One alarm image set containing both the pre- and
post-alarm images is stored in the camera, and then
the alarm image set is transferred one by one to the
"VA-SW3050" software.
Configures the recording capacity ratio
PRE/
between the pre- and post-alarm image
POST
recordings.
Configures the recording rate for the
RATE
alarm image.
Note:
If [PRE/POST] is set at other than "0%/100%", the
[LIVE/NORMAL RECORD (2)] setting cannot be
changed.
When the [BUFFER SIZE] setting is set to "OFF"
When the alarm is detected, only the post-alarm
images will be transferred to the "VA-SW3050"
software. The transfer speed depends on the
network environment.
Specifies the duration of each alarm
image to transfer (During this
DURATION duration, no other alarms can be
processed for transferring the alarm
image).
4 [SET] button
After completing the settings, click this button to
confirm the settings.
17
("admin" only)