Adjusting Subwoofer Settings; Using The High Pass Filter - Pioneer FH-P4000R Operation Manual

Section
Digital Signal Processor
10
3 Press 2 or 3 to select the phase of sub-
woofer output.
Press 2 to select reverse phase and
in the display. Press 3 to select normal phase
and appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press to select the subwoofer setting.
DSP
When the subwoofer output is on, you can
select the subwoofer setting. Press
appears in the display.
80Hz
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
.
125Hz
2 Press 2 or 3 to select cut-off frequency.
Press 2 and
50Hz
is displayed. Only frequencies lower than
125Hz
those in the selected range are output from the
subwoofer.
3 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
the level of the subwoofer (e.g.,
Press 5 or ∞ until you see the desired value
displayed.
48
En
appears
until
DSP
or
50Hz
is displayed. Press 3 and
to ).
+6 –15

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play from
the front speakers, switch the HPF (high pass
filter) on. Only frequencies higher than those in
the selected range are output from the front
speakers.
1 Press to select
DSP
When the rear output setting is subwoofer, you
can select . Press
HPF DSP
the display.
2 Press 5 to turn high pass filter on.
appears in the display. High pass filter
HPF 80Hz
is now on.
• To turn high pass filter off, press ∞.
3 Press 2 or 3 to select a high pass filter
range.
Press 2 and
HPF 50Hz
and is displayed. Only frequencies higher
125Hz
than those in the selected range are output
from the front speakers.
.
HPF
until appears in
HPF
is displayed. Press 3