Epson Stylus Pro 7450 User Manual page 197

The print data in the print buffer is printed with 16-byte hex.
data in the left column and corresponding ASCII characters
in the right column.
Note:
If the last data is less than 16 bytes, it is not printed until you press the
Pause
LANGUAGE
You can select the language to be displayed on the LCD panel.
To select a suitable language, follow the steps below.
1. While in Maintenance mode, press the Paper Feed d button
or Paper Feed u button to display LANGUAGE, and then press
the Menu r button.
2. Press the Paper Feed d button or Paper Feed u button to
select a suitable language.
3. Press the Enter
READY (or similar word in the language selected) appears on
the LCD panel.
Note:
It takes a while until READY (or similar word in the language selected)
appears.
REMAINING PPR SETUP
You can select a paper remaining counter function. When this
function is on, ROLL PAPER COUNTER appears on the PRINTER
SETUP menu.
1. While in Maintenance mode, press the Paper Feed d button
or Paper Feed u button to display REMAINING PPR SETUP,
and then press the Menu r button.
button.
button to set the language. Make sure that
The Control Panel
197