Setting Skip Ids; Clearing Skip Ids - Pioneer PDR-F10 Operating Instructions Manual

Setting skip IDs

1 Press SKIP ID (top panel only)
during playback (or play-pause)
of the track you want to skip.
The indicator lights and the display
SKIP
shows the track number and
• If there's no room left on the disc to record
another skip ID, the display will show the
message
SKIP FULL
2 Press SKIP ID again to confirm.
3 Set further skip IDs by repeating
steps 2 and 3.
4 When you're finished, stop the
disc and press OPEN/CLOSE
(CD-R OPEN/CLOSE on the
remote).
Until you eject the disc, the recorder stores the
skip ID information in its memory. On
pressing /
OPEN CLOSE
the skip ID information onto the disc.
.
SKIP SET
.
, the recorder writes
6 More Recording Features

Clearing skip IDs

1 Make sure that skip play is off.
See above for how to do this.
• If the
SKIP ON
when you loaded the disc then there are
no skip IDs present on that disc.
2 Start playing the track you want
to clear the skip ID for.
3 Press SKIP ID.
The skip indicator blinks and the display
shows the track number (blinking) and
.
CLR
• If this track doesn't have a skip ID, the
player jumps to the next track that does
and starts playback of that track.
• Use the 4 and ¢ buttons to move
between tracks that have skip IDs set.
4 Press SKIP ID again to confirm.
5 Clear further skip IDs by repeat-
ing steps 2–4.
6 When you're finished, stop the
disc and press OPEN/CLOSE (CD-
R OPEN/CLOSE on the remote).
Until you eject the disc, the recorder stores the
changes in skip ID information in its
memory. On pressing
recorder writes the new skip ID information
onto the disc.
indicator did not light
SKIP
/ , the
OPEN CLOSE
29
En