Connecting The Power Cord (1) - Pioneer AVIC-F700BT Installation Manual

Navigation av system
Hide thumbs Also See for AVIC-F700BT:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Section
03
Connecting the System

Connecting the power cord (1)

Note
Depending on the kind of vehicle, the function
of *3 and *5 may be different. In this case, be
sure to connect *2 to *5 and *4 to *3.
Cap (*1)
When not using this terminal,
do not remove the cap.
ISO connector
Yellow/black
If the vehicle can send a mute signal to this terminal, the
mute function can be activated on this navigation system
when the terminal is connected to *8.
Note
In some vehicles, the ISO connector may be divided into two.
In this case, be sure to connect to both connectors.
10
Engb
*1
*3
*2
*5
*4
Yellow (*3)
Yellow (*2)
Back-up
To terminal always supplied
(or accessory)
with power regardless of
ignition switch position.
Red (*4)
Red (*5)
Accessory
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
(or back-up)
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Notes
· When a subwoofer (*9) is connected to this
navigation system instead of a rear speaker, change
the rear output setting in the Initial Setting. (Refer to
"Operation Manual".) The subwoofer output of this
navigation system is monaural.
· When using a subwoofer of 70 W (2Ω), be sure to
connect with violet and violet/black leads of this
navigation system. Do not connect anything with
green and green/black leads.
Connect leads of the
same colour to each
other.
Speaker leads
White:
Front left
White/black: Front left
Grey:
Front right
Grey/black:
Front right
Green:
Rear left
Green/black: Rear left
Violet:
Rear right
Violet/black: Rear right
or Subwoofer
(*9)
or Subwoofer
(*9)
or Subwoofer
(*9)
or Subwoofer
(*9)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avic-f900bt

Table of Contents