GE 164D3333P171 Owner's Manual page 45

Self-cleaning electric ranges coil and glass model
Table of Contents

Advertisement

3
Power Cord Strain Relief Installation
Remove the lower rear range wiring cover to expose the connector block
a
and bracket.
Remove the knockout ring (1
b
connector. To remove the knockout, use a pair of pliers to bend the
knockout ring away from the bracket and twist until ring is removed.
Knockout ring in bracket.
Assemble the strain relief in the hole. Insert the power cord through the
c
strain relief and tighten. Allow enough slack to easily attach the cord
terminals to the connector block. If tabs are present at the end of the winged
strain relief, they can be removed for better fit.
NOTE: Do not install the power cord without a strain relief. The strain relief bracket should
be installed before reinstalling the rear range wiring cover.
Connector box
Wiring cover
(shown removed)
Strain relief
) located on bracket directly below the
3
8
Knockout ring removed.
Ground
strap
Bracket
Strain relief bracket
Power cord
(Provided with range cord. Not part of range.)
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

49-8941Jbp48Jbp79

Table of Contents