g
CAUTION !
Panel "E" should never be removed or replaced with power applied to the UPS.
This panel is in close proximity to 480V live buss bars.
Always disconnect the rectifier, bypass, load and battery sources from the
UPS before removing or replacing this panel.
If not serious injury or death could occur!
How to access the compression lugs for the cable connections.
B
C
To access input, output and Battery Connections proceed as follows:
Unscrew bolts "B" to open the electronics "A".
Remove protection panel "C".
Remove protection panel "D".
Remove protection panel "E".
Remove UPS side panel "F".
OPM_SGS_ISG_M22_M30_0US_V011.doc
A
1
2
3
4
E
D
Fig. 3.8.1-1 Access to the input / output connections
22/38
Top entry cables
Q1
Q2
1
2
3
4
Bottom
entry cables
Installation Guide SG Series 225 & 300 kVA
GE
F